Okay, okay. I’m not going to send the chuck key out without some engraving. Today we’ll use a carbide engraving tool in the high-speed spindle to put a maker’s mark and some other details on the chuck keys, and we’ll address some feedback from the comments on the last video. We’ll talk about setting up Fusion 360 for engraving and generating the GCODE to run the machine.
Tools used in this video:
- Haimer Zero Master Mini 3D Sensor (Amazon*): https://amzn.to/2PVA7mn
- Haimer Short Probe 0.2″ Veraion (Amazon*): https://amzn.to/32Dl9Ir
- Shars 440V 4″ Mill Vise (Amazon*): https://amzn.to/3hZooyD
- ER40 Collet Blocks (*eBay): https://ebay.to/2HmZg7g
- Shars ER-40 Collets (*eBay): https://ebay.to/2RwxoSs
- Shars Ultra Precision 1-2-3 Blocks (pair) (eBay*): https://ebay.to/2RxwqWc
- Aventor 8″ DPS IP54 Caliper (eBay*): https://ebay.to/37y1Tg3
- Angle Block Set (Amazon*): https://amzn.to/2R3Lews
- CRC SL2512 Soluble Oil (Amazon*): https://amzn.to/2qhWswk
- Scotch Brite Maroon Very Fine (eBay*): https://ebay.to/2FzIZco
- Scotch Brite Gray Ultra Fine (eBay*): https://ebay.to/2QRJUXN
- Emery Cloth 1″ Roll (Amazon*): https://amzn.to/3fxodw6
- 3Dconnexion SpaceMouse Compact 3D Mouse (Amazon*): https://amzn.to/2TSJ2q9
- California Air Tools Ultra Quiet 2HP Compressor (Amazon*): https://amzn.to/2TQ926q
*These are affiliate links. When you click one of these links and make a purchase, it helps to support projects like this one.
Raw Kevin MacLeod (incompetech.com) Licensed under Creative Commons: By Attribution 3.0 License http://creativecommons.org/licenses/by/3.0/